Description
These vacuum pods are made from solid PVC. The Pods are exactly 0.950” thick by 5” square. Machined flat on both sides for precision flatness.
Each pod has two mounting locations for a 1/4-20 bolts and room for a socket to tighten down the pod in a fixed location.
Three out of the four pods have two T-type fittings with press connect fittings. To use the fittings, just push the cut hose into the fitting and it locks and seals. To remove the hose, just push in the colored ring while pulling on the hose in the opposite direction at the same time. The fourth Pod has one single press fittings. This is your terminator pod. It is the last pod in the chain and closes up the vacuum as vacuum needs to be sealed for maximum strength.
Note regarding holding and cutting MDF. These pods are NOT recommended for vacuum holding MDF. MDF is very porous and due to this it is very difficult to hold with vacuum unless the side being held is sealed with something like polyurethane.
You receive the following in your order:
FOUR (4) 5”x 5”, 1-sided PVC Vacuum Pods
All required/shown fittings
One Valve
12 ft. of vacuum hose
Extra Gasket Cord
