Description
Our Vacuum Clamps are made from clear acrylic, each with it’s own vacuum seal. Each puck is connected together to cover a large area. You can make your own vacuum table or edge guide. Just fasten these down to your bench or a board. We have supplied general manufacturers, guitar manufacturers, CNC shops, cabinet shops, hobbyist, and all kinds of wood shops for their clamping needs. Cabinet installers use these by screwing them to a board with a level and they vacuum attach to the wall. You then can hold your cabinet in place resting on the board while attaching the cabinet to the wall. These can be attached to the work area for a CNC machine. These can also be attached to a workbench so you can use a router on your work piece, sand or shave the surface of your work piece. When these are set up correctly you can place a wood panel over the pucks, turn on your vacuum pump and you will not be able to pull the panel free. Each disk is 2-1/2” in diameter and accepts the ¼” supplied tubing.
Note regarding holding and cutting MDF. These pods are NOT recommended for vacuum holding MDF. MDF is very porous and due to this it is very difficult to hold with vacuum unless the side being held is sealed with something like polyurethane.
You receive the following in your order:
4 Clear Vacuum Clamps
6 Feet of Vacuum Hose
1 Terminating Rubber Hose Cap
